|
Safety Warnings |
| -
All personnel should be alerted to the potential hazards
indicated by the product safety labeling on this unit. |
The following conventions are used to indicate and classify
precautions in product manuals and on product safety labeling.
Failure to observe precautions could result in injury to people
or damage to property. |
|
 |
This
is the safety alert symbol. It is used to alert you to potential
personal injury hazards.
Obey all safety messages that follow this symbol to avoid
possible injury or death. |
 |
Danger
indicates IMMINENTLY hazardous situation, which, if not
avoided,
WILL result in death or serious injury. |
 |
Warning indicates a
POTENTIALLY hazardous situation, which, if not avoided,
COULD result in death or serious injury. |
 |
Caution indicates a
POTENTIALLY hazardous situation, which, if not avoided,
MAY result in minor or moderate injury. |
 |
Caution used without the safety alert symbol indicates a
potentially
hazardous situation, which, if not avoided, may result in
property damage. |
|
|
This
symbol/pictorial is used to identify an ELECTRICAL SHOCK
or ELECTROCUTION hazard. |
|
|
This
symbol/pictorial is used to identify an ULTRAVIOLET LIGHT
hazard. |
Product safety labels should be periodically inspected and
cleaned, as necessary, to maintain good legibility.
Always replace illegible safety labels. Contact factory to
obtain replacement safety labels. |
|
Safety
Instructions |
WARNING: To guard against
injury, basic safety precautions should be observed, including
the following: |
|
1. |
Read and follow ALL
safety warnings, instructions and notices. |
|
2. |
Do not use equipment for
other than its intended purpose. |
|
3. |
Do not alter design or
construction. |
|
4. |
On units so equipped do not override safety
interlocks. |
|
5. |
Do not remove safety labels
or devices. |
|
6. |
On
units equipped with blowers keep inlet and outlet, vents,
blowers, clean and clear of debris. |
|
7. |
Make sure all panels and
connections are secure. |
|
8. |
WARNING:
Avoid exposure to direct or
strongly reflected germicidal ultraviolet rays.
Germicidal
ultraviolet rays are harmful to the eyes and skin. |
|
9. |
Products intended for indoor use,
equipment should be protected from the elements and from
temperatures below freezing. |
|
10. |
DANGER:
To prevent the risk of severe or fatal electrical shock. Always disconnect power before
performing any maintenance. |
|
11. |
Do not operate if power cord
or plug is damaged. |
|
12. |
Electrical power supplied
MUST match power requirements listed. |
|
13. |
CAUTION:
Do not operate without proper
electrical ground. |
|
|
